Editing Manual Conversion (section)

==Wiring S1/S2==

'''This applies to the series 1 and 2 automatic transmissions ONLY.'''

On the drivers side of the jatco automatic, there is a 8 pin plug on the shift selector.  Tracing it back towards the battery you will find its other end.

A few of these wires will enable you to start your car.

The following is the wiring:
Red + Black and white stripe - Reverse; on the manual gearbox there is a 2 wire plug at the drivers side on the base of the bellhousing.  These must be connected, they are universal, as it is a switch, hooking them up allows you to have reverse lights.

Red with black stripe + Black with Blue stripe- Neutral; join these two into the neutral switch on the gearbox.

Red with black stripe + Black with yellow stripe- Park; join these two together to disable the inhibitor switch, this one will allow you to start your car.

Congrats, you now may start your car.  To test with gearbox out, make sure the starter motor is grounded to the engine block.