Editing Rear Brakes -Reconditioning (section)

==Tools required==

Usual mechanical tools.
Tool for turning the caliper.
I would recomment a piece of aluminium the same size as the big slot in the piston if you wish to make your own.
Circlip pliers (with fairly small points)
10mm open ended possible)
15 mm socket.
13mm socket or spanner.
Big screw driver


;TIP-
:Before you start, inspect all the rubber seals in the kit for imperfections.
:One of the guide pin seals in mine was deformed so I had to use one of the old seals.