Editing Master Cylinder Upgrade (section)

===Removing old master===
Pop the bonnet and position your funnel/container arrangement under a brake line outlet with a rag close by in case you get it dripping on paint. Undo one of the lines and let the fluid run out. Repeat this step with the remaining brake lines.

Undo the two nuts with a 13mm spanner/socket and washers that are holding the brake Master to the Brake Booster, slide the old one out and put it somewhere out of the car, you don't want fluid to drip on stuff. Put the nuts somewhere safe. 

There is a bracket which sits on here that holds the vacuum hose up, you will need to grab your thin flat head screw driver and undo the hose clamps, the easiest way to do this I found was to undo the hose clamp to the right of the bracket and leave it attached to the booster, removing it while it's out of the car is far easier!

[[File:MCUpgrade2.jpg|640px|center|link=]]