Editing Spigot bearing removal (section)

==With a weight==

This is a extension on the dyna-bolt method for removing the auto spigot bearing, which is required for a auto-manual conversion. I believe the dynabolt method usually uses a chisel to provide the the grunt, I've found this way a lot quicker, easier and more successful.

===What you'll need===

#M20 dyna-bolt, as long as possible $4
#Hammer $you should have one already
#A weight off a barbell/dumbbell, I used a 10kg (needs to have the 1/2" hole in the middle)


===Procedure===

*Hammer the dynabolt into the bearing until about 1cm of the sleeve is inside the bearing.  The M20 should be fairly snug in there.

*Once that's in, tighten the dynabolt so that the head is drawn into the sleeve, the tighter you can do it = the better the grip.

*Once you're satisfied it's in there tight, remove the nut on the end, slide the weight on, replace the nut.

*Use the weight like a slide hammer and presto!!! she's out!

[[Image:Spigot weight1.jpg|400px]]

[[Image:Spigot weight2.jpg|400px]]

- '''thrashcar'''