Editing Turbocharging (section)

==Banjo Bolts, Oil + Water lines==


'''Here's some info for banjo bolts and lines, when converting to turbo'''

'''Banjo bolt sizes are:'''

m14x1.5 for water and

m12x1.25 for oil


'''A bit of background info:'''

14 is the top of the bolt size and the other measurement is the thread.

The m14 is a standard hydraulic size and can be purchased from enzed or piretek.


The m12 is not a standard size and can be purchased from Nissan or, just buy a bolt with those specifications and get it made into a banjo... this costs $5 at Pirtek

You also need copper washers, 2 for each eye bolt attachment.

Refer to pic below, left is the home made banjo, right is the washers, m14 from Enzed, and the original Nissan m12

[[image:banjo.JPG]]

Also here's one of my lines, they're all there except for water return, the water feed is a custom.It has been serving me well so far... that metal twisty one to get on was extremely difficult and if doing it again would get custom lines made up.

[[image:lines.JPG]]

Water return howto: a picture tells a thousand words

[[image:turbo2.JPG]]