Editing Aftermarket Seat Installation (section)

=Driver's side=

Grab your driver's seat rails and on them at the front there are 3 holes 2 round holes and a square hole.  File out the square hole with a round file so a M8 bolt can go through it do this to all the seat rails.

Trial fit the seat rails to the seats to make sure you have done it right and the holes line up. 

Here's a photo of where the hole is that needs to be modified:

[[Image:Seats4.jpg|300px]]

Now you have to file out 2 more holes on the seat rails the ones that bolt the seats to the floor pan.  File out the inside seat rail on the drivers side about 5 MM so it moves the seat out and helps clear the hand brake.

Here's a photo of what it should look like when it's installed:

[[Image:Seats5.jpg|300px]]

Now fit the rails to the drivers seat and install it into the car, and BAM a decent drivers seat is in.

Here's a photo of the seat rails what it should look like when you do it:

[[Image:Seats6.jpg|300px]]