Editing Door trim -Re-trimming (section)

==Map Pocket==

The map pocket is the easiest part of all.
Stick your flathead screwdriver into the channel where the carpet sits, and flick the carpet up. Then grab the carpet, and pull it off. How easy was that!?!
Give the plastic a squirt with the adhesive, and let it sit for a minute to get tacky.
Make sure the bit of fabric you're working with has a flat edge. Lay the fabric on the plastic so that the flat edge sits at the top, then poke the fabric under the rim, and press down firmly on the fabric, you may get bubbles/ripples, that's OK, just lift it and try again. If you put it on as I explained (or tried to explain) the fabric should now be on the front and sides of the map pocket.
Make some diagonal cuts from the bottom corners of the fabric, towards the bottom corners of the map pocket.
You may need to make some extra cuts and maybe a fold... if you need to make a fold, be sure that it sits at the bottom so it can't be seen. Then fold the overhangs into the little channel.

Now it might seem like you're finally starting to see the light at the end of the tunnel!