Editing XF Throttle body (section)

=TPS fix=

This is to help the people who do the XF TB conversion and have a bit of trouble with the TPS as I found today with these problems similar to everyone else e.g. throttle sticking with custom brackets when using the Nissan TPS, or having to chop or reposition wires to run the XF TPS (I did not want to cut or reposition wires).

My fix was that if you file back the 3 guides off the XF TPS unit where you plug it in you can turn the plug upside down, thus putting the top wire at the bottom.

I guess where it explains to chop the wire you could but I left it there, if it does nothing what harm can it do.  

-'''DRFT-ME'''


Or you could use ka24 T/B i think its only tiny bit smaller than XF... not sure and is exact same stud pattern and pretty sure the R31 TPS bolts on.

For the XF people have bolted a plate to where the XF TPS bolts to then bolted the R31 TPS to the plate

-'''runnin4life'''


Just got to get the KA24 off a Ti model and it has the twin wheels. although I took the throttle wheels off my RB30 T/B because they look better..........cruise control works a treat too.

While you're at it, may as well bypass the heater hose that runs through the T/B. keeps an indeterminable amount of heat out of that area  Cool back o/t. KA24 is 64mm and direct fit, down to the TPS. XF throttle is a 68mm item and a bit more work involved.

Here is a photo of the KA24 installed, including cruise.

You can also see where I've bypassed the water line so it doesn't pass through the T/B. 

[[Image:Throttle Body Bootinstall015.jpg]]

-'''SMOKEY'''