Editing GTR Injectors - Installing

Remove your injectors, I'm sure you can figure it out.

First up, here is a GTR injector, looks a lot like an RB20 silvertop injector too.

[[File:GTR Injector 1.jpg|center|800px]]

To make these fit, you have to get creative, as you cant use the GTR or RB20 rail as the spacing is a lot different.

First remove the O-ring and the piece of rubber from the base of the tail. Then slip that O-ring back on and slide it down the shaft to the very bottom.

[[File:GTR Injector 2.jpg|center|800px]]

Next up, carefully squeeze a hosetail  made from EFI hose onto the injector, using the little seat from the RB30 injector you're replacing and plonk an EFI clamp on it

[[File:GTR Injector 3.jpg|center|800px]]

Next grab your old injector and some circlip pliers. Remove the circlip from the underside of the injector and then pried out the thick o-ring. WARNING, these pricks are easy to break!

[[File:GTR Injector 4.jpg|center|800px]]

[[File:GTR Injector 5.jpg|center|800px]]

Then reassemble everything on the GTR injector and pop it onto the rail with the others.

[[File:GTR Injector 6.jpg|center|800px]]

Check that your hosetails are the right length and there we are.

[[File:GTR Injector 7.jpg|center|800px]]

'''Gavin'''

[[Category:Engine]]
[[Category:Electrical]]
[[Category:RB30E]]