Oil Sender Unit - Installation: Revision history

Diff selection: Mark the radio buttons of the revisions to compare and hit enter or the button at the bottom.
Legend: (cur) = difference with latest revision, (prev) = difference with preceding revision, m = minor edit.

1 September 2024

  • curprev 08:2308:23, 1 September 2024‎ GavinG7 talk contribs‎ 2,042 bytes +2,042‎ Created page with "Category:Engine Category:Electrical Step 1: Install an oil sender with two ouputs. Image:OilGaugeSender.jpg Connect both wires to the oil sender. There should be two wires in the loom on all skylines. Step 2: If the Ti cluster is installed see if the Oil Gauge works. If it works the job's done. Step 3: If the Oil Gauge doesn't work, a wire needs to be installed between the cluster connector and a connector near the accelerator pedal. The best wire to use..."
Retrieved from "https://test-wiki.r31skylineclub.com/index.php/Oil_Sender_Unit_-_Installation"