Spigot bearing removal: Revision history

Diff selection: Mark the radio buttons of the revisions to compare and hit enter or the button at the bottom.
Legend: (cur) = difference with latest revision, (prev) = difference with preceding revision, m = minor edit.

4 August 2024

  • curprev 13:1313:13, 4 August 2024‎ Session talk contribs‎ 2,832 bytes +2,832‎ Created page with "Category:Gearbox and Drivetrain =Hydraulic Method= Spigot bearing removal by "Hydraulic" pressure This is easy if you have a vernier and a lathe to make a shaft to fit up the inside of the spigot bearing. I used a bolt that was lying around that was the same diameter. As shown in the pics. 500px '''Step 1.''' Pump or fill the inside with grease until it starts to ooze out (as shown in pic) You want to replace all the air inside the cavit..."
Retrieved from "https://test-wiki.r31skylineclub.com/index.php/Spigot_bearing_removal"