VLT Airbox -Installation

Parts

• VL air box top and bottom
• VL cross over pipe
• the little bendy pipe
• square washer bottle -or similar
• some wire -electrical

First remove the original intake setup Remove stock washer bottle Add the crossover pipe and bendy bit Put the afm on the box Now line up the pipes the way they have to go Screw down airbox, it has one slanted corner, screw through that onto the wheel arch Connect the hoses and put the filter in. Hopefully you would put in a k&n or splitfire or somthing similar to help the system

That wasn't so hard was it?! Now all you have to do is go to the wreckers and get a suitable washer bottle that will either fit behind the strut tower or if you have cruise work out where to put it. Now get the wire and extend the harness that went to the orignal washer bottle

Compiled by

r31gav