Editing Rubber Flare Front Lip (section)

==Procedure==

1 - Remove the front bumper bar from your car.

2 - Turn the bumper bar over and sit it on grass (or carpet) so you don't scratch the bar up.

3 - Trim the rubber so it's straight at the end and line it up with the end of the bumper bar.

4 - Attach the first screw into the rubber and then screw it into the bumper bar, be careful that you don't go through and it pokes out through the good side!!!

[[Image:Rubber_lip4.jpg]]

5 - Start screwing it on, I put a screw every 100mm (or 4 inches if you are old school).

[[Image:Rubber_lip5.jpg]]

6 - When you come to the corner you will find that it doesn't want to flex.  Now is where the knife comes in handy, trim the inside edge of the rubber strip so it can flex around the corner and put a screw either side of the corner.

[[Image:Rubber_lip6.jpg]]

7 - Keep on screwing it down.

8 - Do the same as step 6 for the other corner.

9 - It should look like this at this stage.

[[Image:Rubber_lip7.jpg]]

10 - Replace the bumper bar filler panel and grille.

11 - Step back and enjoy how good it looks for a $40 job.

[[Image:Rubber_lip8.jpg]]

[[Image:Rubber_lip9.jpg]]





'''Compiled by:''' AgentR31



[[Category:Cosmetic]]