Editing VLT Airbox -Installation

[[Category:Engine]]
[[category:RB30E]]

'''Parts'''
*VL air box top and bottom
*VL cross over pipe
*the little bendy pipe
*square washer bottle -or similar
*some wire -electrical

First remove the original intake setup
Remove stock washer bottle
Add the crossover pipe and bendy bit
Put the afm on the box
Now line up the pipes the way they have to go
Screw down airbox, it has one slanted corner, screw through that onto the wheel arch
Connect the hoses and put the filter in.
Hopefully you would put in a k&amp;n or splitfire or somthing similar to help the system

That wasn't so hard was it?!
Now all you have to do is go to the wreckers and get a suitable washer bottle that will either fit behind the strut tower or if you have cruise work out where to put it.
Now get the wire and extend the harness that went to the orignal washer bottle



'''Compiled by'''

r31gav